Auto Head Parking
Fall to the surface with a characteristic "crackle". At the same time, they tear off microscopic particles from the surface, consisting of particles of the working layer of the carrier.…

Continue reading →

Our tips
Tip 1 Turn on the Zip drive only for the duration of discarding information with constant monitoring of its operation, so that when clicks appear, inspect the drive in a…

Continue reading →

But this is not Intel at all!
The ways of AMD and Intel, from our point of view, have long diverged. If earlier it was possible to install at least Intel or at least AMD into the…

Continue reading →

document becomes available

Work “the old fashioned way”

Traditionally, if there are 2 … 3 computers in the office, they communicate with each other by a peer-to-peer network. This is a network in which all computers are equitable. No server required. Each user allocates a certain resource for common use (part of the capacity of his hard drive). The printer is also allocated for general use. To work on the Internet, the necessary software and equipment (modem) is installed on one of the computers. Continue reading

Are "stamped" discs really so perfect?
"Stamped" discs (or, if you want, "aluminum") can be made in various ways. The most common is, to be precise, injection molding, rather than stamping. Modern technologies make it possible…

...

Gentlemen's set for office local area network
The composition of the computer equipment used in the office is traditional and is determined by the typical tasks facing employees. Modern business requires the automation of accounting and warehouse…

...

After checking all the computers and installing, where necessary, the recommended boards, will the 2000 problem be resolved?
Of course not! Most of the problems will remain. The danger of the 2000 problem is that in recent years, very large databases have accumulated in any organization. In these…

...

Are "stamped" discs really so perfect?
"Stamped" discs (or, if you want, "aluminum") can be made in various ways. The most common is, to be precise, injection molding, rather than stamping. Modern technologies make it possible…

...