Almost everything about SPD-EEPROM ...
To this day, there are still SDRAM DIMMs operating at 66 MHz frequencies that are not equipped with the SPD-EEPROM chip, which contains the most important time parameters and data…

Continue reading →

Zip Technologies: Pros and Cons
Since the creation of the FDD 3.5 "1.44 MB high-density, a lot of time has passed and this type of media has not undergone any changes during this period, while…

Continue reading →

Work "the old fashioned way"
Traditionally, if there are 2 ... 3 computers in the office, they communicate with each other by a peer-to-peer network. This is a network in which all computers are equitable.…

Continue reading →

areas

Are “stamped” discs really so perfect?

“Stamped” discs (or, if you want, “aluminum”) can be made in various ways. The most common is, to be precise, injection molding, rather than stamping. Modern technologies make it possible to achieve extremely high manufacturing accuracy, however, compact discs made in this way will be prohibitively expensive. Therefore, really “stamped” discs contain many single, at least errors. The main thing is that the available number of errors does not cause a decrease in read speed. Continue reading

Z-tracks
In devices with a moving coil there are no pre-fixed positions. Instead, they use a special guidance system (positioning), which accurately brings the heads to the desired track. The system…

...

“Clicks of Death" - what is it?
This is such a situation when the drive has lost its ability to read the servo track for proper head positioning. At the same time, the drive does not “see”…

...

SDRAM PC100
Until recently, the development of new technologies for manufacturing memory components took place in parallel with the development of chipsets manufactured by Intel. But it so happened that in 1998…

...

Checking the status of the Zip drive
TIP.EXE is a Zip disk surface quality test. The principle of the program is as follows: this program reads each sector of data from the disk, enters them into the…

...